McCain ATC eX2 NEMA, Руководство пользователя

Страница: 22 / 89

16
3 CONFIGURATIONS
The ATC eX2 NEMA controller can be configured depending on the application. In order to properly
configure the controller follow the below directions.
3.1 TS2 Type 1
This is the default configuration for the controller; it uses an SDLC port to communicate to the Bus
Interface Units. The A2 connector in the front panel is used to provide the AC lines (Hot and neutral) and
the chassis ground, also the fault monitor signal and logic ground are provided; connect the AC harness
to the AC INPUT header located on the Control Signals board (M66450A) and the chassis ground wire
(green wire) is attached to the back of the A2 connector.
TS2 Type 1 configuration must be defined through the traffic application running into the controller.
3.2 TS2 Type 2
This configuration is used to handle the MIL-Spec circular connectors of the TS1 standard plus a special
configuration “D” connector (depending on customer requirements) with the TS2 functionality.
For insta
llation refer to the manual of the connectors’ box intended for the application.
TS2 Type 2 configuration must be defined through the traffic application running into the controller.
Note: Connector
’s boxes are supported according to customers’ needs.