Installation and use
COMPUTER XP805
17
5. Programming
The computer has 2 different programming levels, one specific for programming the
L/ha to be distributed and for selecting the type of nozzle used in the work with a
pressure sensor (parameters to be changed often), and one for programming the
“machine parameters” (usually modified only when the machine is modified or
replaced).
5.1 Programming L/ha and selecting the nozzle
Turn on the computer and wait for the test that appears on the numeric display to be
completed. Press the
P
SET/RESET
ROGRAMMING
key repeatedly, which allows you to select the value to
be shown on the display, until the corresponding LED
lights up, then hold
down the
P
SET/RESET
ROGRAMMING
key for about 2 seconds so that you can enter this programming
phase.
The following configuration will appear on the computer:
LOGO
Letter P will flash. With the
+
-
keys you can change the data and than confirm
it by pressing the
P
SET/RESET
ROGRAMMING
key again.
LIVELLO
+
OFF
ON
-
P
SPEED
L/ha
ON
AUTO
L/MIN
1.4
0.6 1.0
0 0.2
2.2
3.0
2.6
1.8
AREA
5.0
4.2 4.6
3.4
SET/RESET
3.8
REGULATION
ROGRAMMING
P
2
1
