Alterations reserved
Operating Manual
SBAP 46/72/82-ME ENG
Stand 01/2004
Page 28
A
5.5
Line-up tapes and line-up table
The shingled sheets are transferred by
the collector table 1 A between the
lower 1 and upper 2 line-up tapes and
transported by them around the drum 3
onto the collector table 4.
The speed of these line-up tapes
may be changed parallel to the
transport tape 1 A as they are driven
by the same motor. The height
adjustment of the line-up rollers 5 –
levelled to the upper edge of the folded
sheets 6 – may be performed through
the crank 7 after the clamping lever 8
has been loosened.
With short signatures, whose upper
edge 6 is deeper than the centre of the
drum 3, the pressure of the upper tape
onto the lower tape may be altered by
means of the line-up rollers:
Clockwise screwing of the red-marked
knurled nut 10 reduces pressure.
Counter-clockwise screwing of the red-
marked knurled nut 10 increases
pressure.
Subsequently, you should secure the
position of the knurled screw by
countering the knurled nut 11.
The speed of the pile transport tapes 12
must be adapted to the production
speed and product thickness.
Low production speed and thin products
require less forward feed, but heavy
products and high production speed
require more forward feed.
continuation
