19
KICK PANEL SPEAKERS
MOUNTING THE KICK PANEL SPEAKERS
Through hundreds of installations, we’ve found once mounting holes are drilled, it’s best to start with the
driver’s side kick panel and then move on to the passenger’s side kick panel to complete the mounting and
wiring of the kick panels. This way you only need the drill out once, then completely finish the left before
moving on to the right. The subwoofer should already be mounted at this stage and both kick panel wires
run to their respective general areas.
STEP 1 – MARK DRILLING SPOTS ON FENDER
Using colored painters tape shown in Figure 14-1a, to mark the interior fender well of the RZR where you
need to drill two mounting holes. To do this, hold an empty left or right pod in your hand. Hold the pod
into place to approximate the position of the mounting holes on the internal fender. Set the unit down and
put colored tape onto the interior fender well area behind the pod until you can see the tape through the
mounting holes when you hold the pod back into place. Next, use a permanent felt-tipped marker to mark
the mount holes on the painter’s tape as shown in Figure 14-1b. Repeat this process on the passenger’s
side kick panel area.
STEP 2 – DRILL HOLES
Drill (2) 5/16 inch mounting holes into the fender where you marked the tape shown in Figure 14-2. Repeat
this process and drill two more 5/16 inch mounting holes on the passenger’s side kick panel area. Remove
any tape in the drilling area from the interior fender wells.
STEP 3 – PUSH OUTER BOLTS THROUGH FENDER AND KICK PANEL
With the included hardware push (1) bolt and (1) washer mount through the fender into the pod. This leaves
only the head of the bolt visible behind the tire shown in Figure 14-3.
NOTE
- Wait to mount passenger kick panel until driver’s side
panel is completely mounted and wired.
Figure 14-1a
Figure 14-1b
Figure 14-2
Figure 14-3
