Black plate (210,1)
q
Stowing the wheel
CAUTION
Do not raise the spare wheel carrier
without the wheel attached. Damage
can occur to the winch mechanism if
lowered without a wheel attached.
1. Place the wheel flat on the ground, so
the outside of the wheel faces down.
Tilt the bracket, and pass it and the lead
through the centre opening in the
wheel.
2. Fully insert the flat end of the wheel
brace into the guide hole and turn
clockwise.
3. Stow the wheel brace, jack, and jack
handle away.
TYRE CARE
To make sure the front and rear tyres of
your vehicle wear evenly and last longer,
we recommend that you swap the tyres as
per the graphic at regular intervals of 10
000 km (6 000 miles).
WARNING
If the tyre label shows different tyre
pressures for the front and rear tyres
and the vehicle is equipped with a tyre
pressure monitoring system, then the
settings for the system sensors need to
be updated. Always perform the system
reset procedure after tyre rotation. If
the system is not reset, it may not
provide a low tyre pressure warning
when necessary. See the tyre pressure
monitoring system reset procedure in
this chapter.
CAUTION
Do not scrub the sidewalls of the tyres
when you are parking.
202
Wheels and Tyres
Mazda BT-50_8FX5-EI-17DT_Edition2 Page210
Thursday, May 11 2017 5:34 PM
Form No.8FX5-EI-17DT