Mazda 626 Station Wagon, Руководство по ремонту

Страница: 254 / 577

AUTOMATIC TRANSAXLE
SE R VO APPLY
2. Install the control valve body component.
Tightening torque
7.9—10.7 N-m
{80— 110 kgf*cm, 70—95.4 inlbf}
Bolt length (measured from below the head)
B: 40 mm {1.575 In}
No mark: 70 mm {2.756 In}
3. Install the oil strainer.
4. Match the harness colors, then connect the
solenoid connector and TFT sensor connector.
Solenoid valve
Color of connector
(harness side)
Pressure control solenoid Black
Shift solenoid A White
Shift solenoid B Blue
Shift solenoid C
Green
Shift solenoid D White
Shift solenoid E Black
5. Install the ground.
Tightening torque
7.9—10.7 N-m {80—110 kgf-cm, 70—95.4 in lbf}
T F T
SENSO R
SHIFT
SO LENO ID E
SH IFT
SOLENO ID D
S H IFT
SO LENO ID
B
PRESSURE
CONTRO L
SOLENOID
G ROUND
S H IFT
SOLENO ID C
SHIFT
SOLENO ID A
6. Apply a light coat of silicon sealant to the contact
surfaces of the oil pan and transaxle case.
SEALANT
7. Install the oil pan.
Tightening torque
5.9—7.8 N-m
{60—80 kgf-cm, 53—69 in lbf}
8. Install the splash shield.
9. Connect the negative battery cable.
10. Add ATF and with the engine idling, inspect the
ATF level. (See K2-29 AUTOMATIC TRANSAXLE
FLUID (ATF) REPLACEMENT.)
11. Carry out the mechanical system test. (See K2-21
MECHANICAL SYSTEM TEST.)
12. Carry out the road test. (Refer to K2-24 ROAD
TEST.)
K 2-47