BRAKE FLUID AIR BLEEDING
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id041100815300.html[1/7/13 9:32:32 AM]
2013 - CX-5 - Brakes
BRAKE FLUID AIR BLEEDING
CAUTION:
Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If
it is spilled, wipe it off immediately.
NOTE:
Keep the fluid level in the brake fluid reserve tank at 3/4 full or more during the air
bleeding.
Begin air bleeding with the brake caliper that is furthest from the master cylinder.
Brake fluid type
SAE J1703 or FMVSS116 DOT-3
1. Remove the cap from the brake fluid reserved tank and add brake fluid.
2. Remove the bleeder cap on the brake caliper, and attach a vinyl tube to the bleeder screw.
3. Place the other end of the vinyl tube in a clear container and fill the container with fluid
during air bleeding.
4. Working with two people, one should pump the brake pedal several times and depress and
hold the pedal down.
5. While the brake pedal is depressed, the other should loosen the bleeder screw using a
commercially available flare nut wrench, drain out any fluid containing air bubbles, and tighten
the bleeder screw.
Tightening torque
6.9—9.8 N·m {71—99 kgf·cm, 62—86 in·lbf}
6. Repeat Steps 4 and 5 until no air bubbles are seen.
