Mazda 2007 CX-7, Руководство по ремонту кузовов

Страница: 12 / 138

GENERAL INFORMATION
00-00–10
Prevention of Body Deformation
•
Use a clamp or a jack for removal and reinforce at
and around the rough-cutting location to prevent
deforming of the body.
Selection of Cut-and-join Locations
•
For parts where complete replacement is not
feasible, careful cutting and joining operations
should be followed. If the location to be cut is a
flat area where there is no reinforcement, the
selected cutting location should be where the
welding distortion will be minimal.
Removal of Associated Parts
•
Protect moldings, garnishes, and ornaments with tape when removing associated parts.
Rough Cutting of Damaged Panel
•
Verify that there are no parts (such as pipes, hoses, and wiring harness) nearby or on the opposite side of a
panel which could be damaged by heat.
•
For cut-and-join areas, allow for an overlap of
30—50 mm {1.18—1.97 in} and then rough-cut
the damaged panel.
End Of Sie
INSTALLATION PREPARATIONS
id000000600400
Rough Cutting of New Parts
•
For cut-and-join areas, allow for an overlap of
30—50 mm {1.18—1.97 in} with the remaining
area on the body side and then rough-cut the new
parts.
acxuub00000066
acxuub00000067
Wiring harness
Rough cut location
Cut-and-join location
acxuub00000047
Over lap
Over lap
Body side rough cut location
New part rough cut location
30-50mm{1.18-1.97in}
30-50mm{1.18-1.97in}
acxuub00000048
3419-1U-06C(00-00).fm 10 ページ ２００６年３月２２日 水曜日 午後４時１４分