Fig. 78: Removing Rear Airdam Skirt (BP With TC)
Courtesy of MAZDA MOTORS CORP.
REAR AIRDAM SKIRT INSTALLATION (BP WITH TC)
1. If installing a new rear airdam skirt, perform the following procedure:
1. Using a cutter, remove any remaining double-sided tape from the rear bumper.
2. Remove any grease or dirt from the rear bumper affixing surface.
2. If reusing the rear airdam skirt, perform the following procedure:
1. Using a cutter, remove any remaining double-sided tape from the rear airdam skirt and rear
bumper.
2. Remove any grease or dirt from the rear airdam skirt and rear bumper affixing surfaces.
3. Affix double-sided adhesive tape to the rear airdam skirt as shown in the figure.
3. Peel back the tape backing
approx.3 cm
from each end and fold towards the exposed surface of the rear
airdam skirt.
WARNING:
Using a cutter with bare hands can cause injury. Always wear gloves
when using a cutter.
NOTE:
If installing a new rear airdam skirt, double-sided adhesive tape is already
affixed to the skirt.
2005 Mazda MX-5 Miata
2005 ACCESSORIES & EQUIPMENT Exterior Trim - MX-5 Miata
Microsoft
Saturday, July 04, 2009 12:04:29 PM
Page 76
© 2005 Mitchell Repair Information Company, LLC.
