Installation and Operational Instructions for
ROBA-stop
®
Holding Brake Type 820.61_._
(B.1110.6.GB)
08/02/2010 K/GC/RJ/GF
Chr. Mayr GmbH + Co. KG
Tel.: 08341 / 804-0
Eichenstraße 1
Fax: 08341 / 804-421
D-87665 Mauerstetten
http://www.mayr.de
Page 1 of 8
Germany
eMail:
Please read these Installation Instructions carefully and follow them accordingly!
Ignoring these Instructions may lead to malfunctions or to brake failure, resulting in damage to other parts.
Contents:
Page 1: - Contents
- Declaration of Conformity
Page 2: - Safety Regulations
Page 3: - Safety Regulations
Page 4: - Brake Illustrations
- Parts List
- State of Delivery
- Function
Page 5: - Installation Conditions
- Installation
- Air Gap Adjustment
- Braking Torque Adjustment
Page 6: - Brake Inspection
- Replacing Worn Parts
- Hand Release Installation
- Hand Release Adjustment
- Hand Release Parts List
Page 7: - Electrical Connection
- Terminal Box Installation
Page 8: - Maintenance
- Disposal
- Malfunctions / Breakdowns
Declaration of Conformity
A conformity evaluation for the applicable EU directives has been carried out for this product.
The conformity evaluation is set out in writing in a separate document and can be requested if required.
It is forbidden to start use of the product until the machine or system into which it should be built is operating in accordance with all
applicable EU directives.
Without a conformity evaluation, this product is not suitable for use in areas where there is a high danger of explosion.
This statement is based on the ATEX directive.
Please Observe!
According to German notation, decimal points in this document are represented with a comma (e.g. 0,5 instead of 0.5).
