Mayku Multiplier MMUA22100AA, Инструкция по установке и эксплуатации

Страница: 30 / 42

5.1.7 Checks before using the machine
1. Ensure the machine is on a level and even surface
2. Ensure both safety release valves have clearance and are not obstructed.
3. Ensure the machine is clean and clear of debris
4. Ensure the heaters are not cracked or broken
5. Ensure the reflector is free from dust or debris
6. Ensure that no objects or debris are obstructing the temperature sensor
7. Ensure that the seal is clean and even, with minimal warping and distortion.
See section 6.1 to clarify the above operations.
5.2 What to do in emergency and exceptional situations
Make sure you know where the emergency stop buttons are located before operating the
machine.
To emergency shut down your machine, switch off the machine at the mains, lower the lid and
unlock both locks.
All activities of the machinery are then aborted. Once ready, the machine can
be turned back on with no reset required.
5.2.1 Emergency situation
In the case of an overheating / fire event:
1. Switch off the machine at the mains and close the lid immediately (if possible).
2. A CO2 or powder fire extinguisher shall be used due to electrical components in the
machine.
3. Do not attempt to repair the machine, all repairs shall be carried out by a trained
professional.
In the case of an overpressurisation event:
1. Switch off the machine at the mains and allow it to cool down.
2. To vent the dome, pull down on the ring tab on the safety release valve, positioned on
the base of the machine (bottom rear, see diagram in section 2.5 ).
3. To vent the tanks, pull down on the ring tab on the safety release valve, positioned on
the base of the machine (bottom front, see diagram in section 2.5 ).