Maxxon Express II Kayak 2011, Руководство пользователя

Страница: 5 / 6

5
MAINTENANCE
1. To deflate the kayak, remove the valve cap from the valves in the kayak floor and kayak body.
2. Clean and check the kayak as well as all the accessories. Make sure the kayak is completely dry before putting it away.
Make sure that no sand nor gravel remains inside the kayak nor between the hull and the inner chambers: this could result in
abrasion or even punctures while storing the kayak.
3. Fold the 2 sides into the middle, then roll it up from the opposite end of the valves (so remaining air can escape from the valves).
4. When storing your inflatable, keep it in a clean and dry place.
Whenever you take your kayak out of the water and deflate it, allow time for it to air out and dry. Neither the
skin/hull or the inside chambers will suffer from water damage, but stagnant water could cause mildew and
foul odor.
HOW TO REPAIR SMALL PUNCTURES
Check that the tube is fully deflated and lies flat.
1. Prepare a round patch no less than 3 inches or 7 centimeters in diameter.
2. Clean the patch and the area surrounding the leak with Alcohol.
3. To contain excess glue, use masking tape to tape off the area around the patch.
4. Apply 3 thin, even coats of repair kit adhesive to both the surface of the kayak and the patch. Wait 5 minutes between each coat.
5. After the 3
rd
coat, wait 10-15 minutes before applying the patch. Use a hand roller to apply the patch evenly. Pay special
attention to the edges.
6. Wait 24 hours before re-inflating.
• Perform all of your repairs in a well-ventilated area.
• Avoid inhaling glue vapors.
• Avoid contact with the skin or the eyes.
• Keep all repair materials (glue, solvents, etc) away from the reach of children.
• The repairs on the welds must not be glued. Only the manufacturer of the kayak can perform repairs on
the welds themselves.
WARRANTY
MAXXON warrants (legal warranty) to the original purchaser only, and from date of purchase, that the product is free from defects.
The warranty applies only when this product is used for normal recreational purposes. Check with your local MAXXON office for
details on the length of this warranty, which varies for different countries. The warranty does not cover any puncture, cut or abrasion
sustained in normal use or damage from unreasonable uses or improper storage. If any product is found to be defective, the owner
may return it to the store where it was purchased along the original sales receipt. After inspection of any product found defective,
MAXXON shall either repair or replace the defective part or item as deemed necessary by MAXXON. MAXXON shall not be held
liable for incidental and consequential damages. There are no warranties which extend beyond the description of the face hereof.
This warranty is in lieu of all other warranties. This warranty gives you specific legal rights and you may also have other rights,
which may vary, from country to country.
The main limitations to the application of this warranty are the following;
• The item must not be modified and/or fitted with a motor in excess of that allowed by the manufacturer or used in any activities
outside normal recreational use (such as races, rental, or commercial usage).
• Used in excess of the manufacturers recommended maximum load capacity.
• Pressure recommendations, assembly / disassembly and handling procedures must be strictly observed.
• The maintenance and the storage procedures must not be neglected.
• This warranty does not cover parts and accessories not supplied or recommended by the manufacturer or defects resulting from
the installation of such equipment on their products.
ALL REPAIRS COVERED BY WARRANTY MUST BE PERFORMED BY MAXXON.
This product is designed in accordance with standards for a specific use. Any modifications, transformations
or use of a motor horse power higher than that indicated by the manufacturer could result in serious risks
for the user and will void the warranty.