Maxwell MW-1985, Инструкция по эксплуатации

Страница: 8 / 24

8
ENGLISH
rience or knowledge if they are not under
supervision of a person who is responsible
for their safety or if they are not instructed
by this person on the usage of the unit.
• Do not leave children unattended to pre-
vent using the unit as a toy.
• During operation and breaks between
operation cycles, the unit should be placed
out of reach of children.
• For children safety reasons do not leave
polyethylene bags, used as packaging,
unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
• Periodically check the power cord and
power plug integrity.
• Never use the unit if the power cord or the
power cord plug is damaged, if the unit
works improperly or after it was dropped.
• Do not attempt to repair the unit. Do not
disassemble the unit, if any malfunction is
detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given
in the warranty certificate and on the web-
site www.maxwell-products.ru.
• Transport the unit in the original package
only.
• Keep the unit out of reach of children and
disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY, ITS COMMERCIAL USAGE AND
USAGE IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.
BEFORE THE FIRST USE
In case of the unit transportation or stor-
age under cold (winter) conditions, it is
necessary to keep it for at least three
hours at room temperature.
–
Before switching the unit on for the first
time, make sure that the mains voltage cor-
responds to the voltage specified on the
unit body.
–
Unpack the grill, remove any advertising
stickers and package materials that can
prevent the unit operation.
–
Remove the grid (4).
–
Lift the front part and remove the heating
element (7).
–
Clean the heating element (7) and the base
(8) with a slightly damp cloth, and then
wipe dry.
–
Wash the grid (4) with warm water and soft
detergent, rinse it and dry.
–
Place the base (8) on a flat steady surface
away from the sources of moisture, heat
and open flame with free access to the
mains socket.
–
Fill the base (8) with water up to the mark
«МАХ» (6).
–
Place the heating element (4) on the base
(8), to do that insert the ledges on the rear
part of the heating element (7) into the
openings on the base (5) and lower the
front part of the heating element (7) in the
installation place.
–
Insert the power plug into the mains sock-
et, turn the temperature control knob (9)
and set it to the position «MAX», the light
indicator (10) will light up.
–
When the heating element (7) heats up to
the set temperature, the light indicator (10)
will go out. Switch the grill off by setting the
temperature control knob (9) to the posi-
tion «MIN» and unplug it.
–
Wait until the grill cools down comple-
tely.
–
Do not move hot grill, wait until it cools
down completely and carry it by the han-
dles (3).
Note: – During the first grill operation the
heating element (7) burns, therefore occur-
rence of a small amount of smoke or foreign
smell is possible. It is normal and is not a sign
of malfunction.
FOOD COOKING WITH THE GRILL
ATTENTION!
• Water in the base (8) decreases the heat-
ing temperature of the surface the grill is
placed on.
• During cooking always check the water
level (6). If the water level goes below the
mark «MIN» (6), switch the grill off, remove
the heating element (7) and only after that
IM MW-1985.indd 8 24.07.2018 11:52:28