15
If a device is not working, or you need to change the setup of the system, you may
need to replace or delete wireless devices. Follow the appropriate procedure in this
section.
5.1 Replacing Devices
Wireless devices are divided into the following classes:
Class
Model
2
WLS905, WLS907
3
WLS904
4
WLS906
5
WLS908
6 & 9
WLS909
7
WLS910
This section describes how to replace one device with another device of the same
class. All programming that was used with the old device will be used with the
new device. For example, a WLS905 can be replaced with a WLS907, or a WLS910
can be replaced with another WLS910.
1. At a system LCD keypad, enter [*][8][Installer’s code].
2. Enter Ref #[001302] to go to the Replace Device section. The LCD keypad will
display
Serial # [ ]
and either
Zone XXX
, Wkey# XX or HHK# XX
3. Use the [<][>] keys to scroll to the device to be deleted, then press [*]. The LCD
keypad will display
With Device
Serial# [ ]
.
4. Enter the serial number of the new device. The LCD keypad will display Device
Replaced Serial # [ ] Zone XXX
NOTE
: You cannot replace devices of different classes. (For example, a motion detector
cannot be replaced by a universal transmitter.) If you need to do this, you must delete
the first device (see Deleting Devices, below) and enroll the second. You will also need
to change the programming for the new device. See Section 3: Installing WLS9XX
Wireless Devices.
NOTE:
To change the partition a handheld keypad is assigned to, you must delete and
then re-enroll the keypad.
5. To exit, press [#].
S E C T I O N 5
Deleting & Replacing Devices
