XPress
Ethernet
Bridge
™
Product Manual - Industrial/Outdoor XEB09-I
Create long range wireless links in minutes!
Connect any Ethernet device to the XPress Ethernet Bridge
RF Modems and the bridge will function in place of
an Ethernet cable. The Ethernet bridge provides a
transparent wireless point-to-point cable replacement.
www.maxstream.net
© 2006 MaxStream, Inc. All rights reserved.
M100258
Introduction
This manual provides step-by-step instruction on how to setup a wireless link and test the
Ethernet Bridge’s ability to transport data over varying ranges and conditions.
Included with the XPress Ethernet Bridge (Industrial)
(2) XPress Ethernet Bridge RF Modems
(2) 6 VDC/80-240 VAC power adapters (not included w/ version XEB09-I-AU (Australia))
(2) Power over Ethernet Injectors
(2) 30’ CAT5e Outdoor Cables
(2) CAT5e outdoor cables, 30’ (9m)
Quick Setup
Hardware Setup
Each RF Modem automatically selects the best radio channel, encrypts the Ethernet traffic and
transports the data wirelessly to its matched pair. Cross-over cables are not necessary since the
RF modems automatically sense the device (client vs. switch).
Figure
1.
Ethernet
Bridge
Setup
1. Using the power adaptors, plug in each of the XPress RF Modems to an outlet.
2. Connect an Ethernet cable from each XPress RF Modem to a network device.
3. Send Ethernet traffic through the wireless Ethernet Bridge [for troubleshooting, refer to
the following page].
