MaxPro MPPO1200/180VC, Руководство пользователя

Страница: 10 / 100

P Polisher MPPO1200/180VC User Manual
10
CLEANING AND MAINTENENCE
Protect the tool from impact, shock and grease Always keep tool and cord clean (especially ventilation
slots)
disconnect the plug before cleaning
do not attempt to clean ventilation slots by inserting pointed objects through openings
ENVIRONMENT
Do not dispose of electric tools, accessories and packaging together with household waste material
- in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compatible recycling facility
TROUBLE SHOOTING
NO Fault Symptom Possible Cause Troubleshooting
1 Out of service
Disconnection between plug and power
socket
Put plug in power socket
shortcircuit in power supply Repair and reconnection
At switch-off Switch on
Loose switching contact Replace switchboard by repairer
Constant speed regulating block damaged
Replace constant speed regulating block by
repairer
Burnout of stator or rotor coil Replace stator or rotor by repairer
Stator wiring disconnection Reconnection by repairer
Disconnection between carbon brush and
commutator or run-out of carbon brush
Replace carbon brush
2
Sluggish start-up,
falling short of
running speed
Unsmooth running in mechanical part Check mechanical part by repairer
Low supply voltage Regulate supply voltage
Constant speed regulating block damaged
Replace constant speed regulating block by
repairer
Burnout of switch contact Replace switchboard by repairer
3
Excessive sparkling
during running
Underpressure in carbon brush spring Replace carbon brush by reparier
Excessive wearout of carbon brush Replace carbon brush by reparier
Ring fire caused by shortcircuit in rotor
winding shortcircuit
Check or replace rotor by repairer
Ring fire caused by shortcircuit in
commutator segment
Check or replace rotor by repairer
Overvoltage in supply power Regulate supply voltage
Disconnection between carbon brush and
commutator
Replace carbon brush
4
Excessive machinery
noise
Electric motor at fault Check motor by repairer
Gear wheel or rotor tooth damaged Replace gear wheel or rotor
Polishing disc damaged Replace polishing disc
5
Failed to reach rated
power
Electrocircuit overload due to lighting
device, public utility or other electric
appliances
No use of public utility or other electric
appliances on machine-connected
electrocircuit
6
Machine
superheating
Electromotor overload Overload protection
Insufficient motor cooling Dedust air outlet
GB