Maxon TUK-A-WAY 80-3LM, Руководство по установке

Страница: 24 / 36

11921
Slauson
Ave.
Santa
Fe
Springs,
CA.
90670
(800)
227-41
16
F
AX
(888)
771-7713
PAGE 24
DECALS, 80 SERIES
These Decals are located
on the rear corner post of the
vehicle, at the control position.
They should be read completely
and understood before operating
the Lift Gate. They should also be
kept clean and readable at all
times. If any decal should become
detatched from the vehicle, or
defaced, it must be replaced. Free
replacements are available from:
MAXON Lift Corp ., Parts Dept.
CAPACITY DECALS
SIZE PART NO.
3000 LBS.
4000 LBS.
220388
220389
Operating Decal
P/N 262433
Capacity
Decal
Warning Decal
P/N 260008
Safety Hook Decal
P/N 263988
(Placed on both sides of
Extension Plate)
Unhook Safety Chain
Before Lowering Liftgate
P/N 263998
WARNING
READ CAREFULLY
• Improper operation of this Lift can result in serious personal injury.
Do not operate unless you have been properly instructed and have
read, and are familiar with the operating instructions. If you do not
have a copy of the instructions, please obtain them from your
employer, distributor, or lessor, before you attempt to operate Lift.
• Be certain that the vehicle is properly and securely braked before
using the Lift.
• Always inspect this Lift for maintenance or damage before using it. If
there are signs of improper maintenance, damage to vital parts, or
slippery Platform surface, do not use the Lift until these problems
have been corrected.
• Do not overload the Lift. The load limit is based on evenly distrib-
uted cargo over the entire Platform surface. If you are using a pallet
jack, be sure it can be maneuvered safely. Do not operate a forklift on
the Platform or travel with the platform in an open position at any time.
• Load should be placed in a stable position close to the edge of the
Platform nearest the truck. The heaviest portion of the load should
never be placed beyond the center of the Platform away from the
truck.
• Never allow yourself, a helper, or bystander to stand in a position
where a falling load could land on either of you. Also do not allow any
part of yours or your helper’s body to be placed under, within, or
around any portion of the moving liftgate, or it’s mechanisms, or in a
position that would trap them between the platform and the ground or
truck when the liftgate is operated.
• If a helper is riding the Platform with you, make sure you are both
doing so safely and that you are not in danger of coming in contact
with any moving or potentially moving obstacles. USE GOOD
COMMON SENSE. If load appears to be unsafe, do not lift or lower it.
MAXON LIFT CORP. PART NO. 264081
!
!
P/N 250993
P/N 251838
To Tuck Unit Away after Use,
Reverse Steps 1 thru 4
Activate Toggle
Switch to Raise or
Lower Platform
Open Flipover
Open Platform
Activate Toggle
Switch to Lower
Stowed Lift Gate
This point must
touch the ground
OPERATING INSTRUCTIONS
GPT & 80-3/4 Units
Unhook Safety
Chain First.
1
2
3
4
5
6