maxon motor control
EPOS2 P Programmable Positioning Controller
Document ID: rel5876
1-5
EPOS2 P 24/5 Hardware Reference
Edition: May 2016
© 2016 maxon motor. Subject to change without prior notice.
1
About this Document
1.1
Intended Purpose
The purpose of the present document is to familiarize you with the described equipment and the tasks
on safe and adequate installation and/or commissioning.
Observing the described instructions in this document will help you …
•
to avoid dangerous situations,
•
to keep installation and/or commissioning time at a minimum and
•
to increase reliability and service life of the described equipment.
Use for other and/or additional purposes is not permitted. maxon motor, the manufacturer of the equip-
ment described, does not assume any liability for loss or damage that may arise from any other and/or
additional use than the intended purpose.
1.2
Target Audience
This document is meant for trained and skilled personnel working with the equipment described. It con-
veys information on how to understand and fulfill the respective work and duties.
This document is a reference book. It does require particular knowledge and expertise specific to the
equipment described.
1.3
How to use
Take note of the following notations and codes which will be used throughout the document.
Table 1-1
Notations used in this Document
Notation
Explanation
(n)
referring to an item (such as order number, list item, etc.)
denotes “see”, “see also”, “take note of” or “go to”
