maxon motor
EPOS 24/5 Getting Started
EPOS Positioning Controller
10.
‘Startup Wizard’
Step 8 for EC motors: Summary
a)
A short summary of the most important
configuration values is displayed in this
window.
b)
If there are any mistakes in the
configuration, you can go back and modify
the values by clicking on the button
‘Zurück’.
c)
If you will not start the startup wizard at the
beginning of every EPOS user interface
session, you have to deselect the option
‘Always start this wizard after program
start’.
Figure 22: Startup wizard dialog for setting
EC motor encoder resolution
d)
If all settings are correct, click the button
‘Fertig stellen’ to close the startup wizard.
11.
Save and activate parameters
Figure 23: Save & activate the configured parameters
a)
Click the button ‘Yes’ to accept the parameters.
Figure 24: Confirm parameter activation
b)
Confirm by clicking the ‘OK’ button.
December 2008 Edition / document number 573050-07 / subject to change
maxon motor control
19
