• To reduce the risk of death, personal injury or property damage from
fire, electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or
maintenance of the luminaires, consult a qualified licensed electrician
and check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junction box.
WARNING:
• Risk of Fire - Supply conductors (power wires) connecting the fixture
must be rated min. 75°C Supply Conductors. If uncertain consult an electrician.
• Risk of fire or electric shock. installation requires knowledge of
luminaires electrical systems.
• Risk of Fire/Electric Shock - If not qualified, do not attempt installation. Contact a qualified electrician.
• Do not use in high humidity conditions.
• Keep away from flammable and explosive environment.
• Don’t cover the fixture with insulation liner or similar material.
• Don’t install where fixture is loose or only partially supported.
• Don’t impact or exert pressure on the fixture surface face or rear, as damage may occur.
CAUTION:
• For your safety read and understand instructions completely before starting installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects.
• Before attempting installation, check your local electrical code, as it
sets the wiring standards for your locality.
NOTES:
• If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire is
connected to the switch. DO NOT connect the white supply wire to the switch.
• Make certain no bare wires are exposed outside the wire nut connectors.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during
kit installation.
Model:
MSF Series
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 1
REV: 03/15/22
General Safety Information
Operating Instructions
MSF Series
MaxLite LED Slim Flood Fixtures (15W-140W)
®
Picture is for illustration purposes only.
Your model may vary.