6) Secure face plate to housing.
Back Mounting
INSTALLATION INSTRUCTIONS FOR COMBINATION
EMERGENCY EXIT LIGHT
IMPORTANT SAFEGUARDS:
When using electrical equipment, basic safety precautions should always be followed.
Including the following
1) READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2) Do not use outdoors.
3) Do not mount near gas or electric heater.
4) Use caution when handling batteries. Avoid possible shorting.
5) Equipment should be mounted at heights to prevent tampering by unauthorized
p
ersonnel.
6) The use of accessory equipment is not recommended by the manufacturer, this
may cause unsafe conditions.
7) Do not use this equipment for other than the intended use.
8) Save these instructions.
IMPORTANT:
When relamping, only use lamps specified in the exit sign.
Using other lamp types may result in transformer damage or unsafe conditions.
Battery in this unit may not be fully charged.
After electricity is hooked up to unit, let the battery charge up for at least 24 hours.
Then normal operation of this unit should take effect.
Ceiling Mounting
Installation Instructions
:
1)
leads to A.C. input leads in J-box, fasten J-box bracketto J-
"
Connect 20 jumper
box. Use Black wire for 120 volt, Red wire for 277 volt, White wire is common.
2) Fasten canopy to J-box bracket.
3) Snap housing to canopy.
4) Connect and trim input leads to socket leads at upper left corner of housing wire
channel.
6) Secure face plate to housing. Remove the proper arrow as required.
1)
leads to A.C. input leads in J-box.Use Black wire for 120 volt,
"
Connect 20 jumper
2) Remove necessary knockouts and fasten back cover to J-box.
3) Snap housing to back cover.
4) Connect and trim input leads to socket leads at upper left corner of housing wire
channel.
Red wire for 277 volt, White wire is common.
5) Mount two
R
emote lamp head at most.
5) Mount two
R
emote lamp head at most.
