Maxima 08560210, Перевод оригинального руководства по эксплуатации

Страница: 6 / 14

5
vents; must be equipped with the proper electrical and hydro systems, built in accordance with the
standards related to facilities and workplace safety in the country of installation.
The maximum working height, referring to the highest surface level, must be 1.6 metres from the floor.
After installing the appliance, if required, apply the suitable adhesive symbol (supplied) at a height of
1.6 metres. To favour air circulation around the appliance, leave a space of about 10 cm between the
appliance sides and the surrounding walls (or other appliance), and between the back and the back wall
(see the attached “Technical Data Sheet”). The appliance must be positioned so that the rear wall is easily
accessible to set up various electrical connections and to carry out any possible maintenance. Do not install
the appliance near any equipment that may reach high temperature values (e.g. deep fryers).
Should the appliance be installed near walls, shelves, counters and the like, these must be non-flammable
or heat-resistant; otherwise, they must be protected by adequate fire retardant coating. Accordingly, it is
indispensable to act in compliance with the fire prevention regulations in force.
Cooking produces hot smoke/vapour and odours which are extracted through the suitable vent device
located at the top of the appliance and marked with the symbol .It is recommended to place the
appliance under an extraction hood or to use the suitable condensation hoods in order to convey the
smoke/vapour to the outside.
Warnings
Make sure there are no objects and/or materials obstructing the oven’s exhaust device.
The hot smoke/vapour produced during cooking must run freely out of the exhaust device in order not to
compromise the regular operation of the oven.
Inflammable materials must not be left near the oven’s exhaust device.
2.6.1 Table top oven placement
The appliance must be placed in a perfectly horizontal position on a table or similar support; never on the
floor. To facilitate oven levelling, the feet are adjustable in height.
For safety reasons it is recommended to use the specific table produced; otherwise the dimensions and
weight of the appliance must be taken into account.
The appliance is unsuitable for recessed installation and cannot work without the 4 supporting feet.
Warning
If the appliance is positioned on a wheeled table/support, ensure that the intended movement does not
damage electrical wires, water pipes, drain pipes or anything else.
2.7 Electrical connection
The appliance’s connection to the electric power network and the connection systems must comply with
the applicable regulations in the country of installation. Before setting up the electrical connection ensure
that:
the voltage and frequency of the power supply system match the specifications of the "technical data"
plate affixed to the side of the appliance;
the power supply system is able to withstand the appliance's load (see "technical data" plate);
the power supply system is fitted with an effective earthing connection according to the regulations in
force;
in the permanent connection to the electric power network, a protective pole switch must be placed
between the appliance and the mains (e.g. circuit breaker) with minimum opening between the contacts of
overvoltage category III (4000V) and a differential switch, sized for the load and complying with applicable
regulations.
the protective pole switch used for the connection is easily accessible when the appliance is installed;
the yellow/green earthing cable is not interrupted by the switch;