Maxima 08560210, Перевод оригинального руководства по эксплуатации

Страница: 5 / 14

4
1. TECHNICAL SERVICE

It is essential for this instruction manual to be stored together with the appliance for future referencing;
in the event of misplacing it, a copy must be obtained directly from the manufacturer.

This information has been prepared for your safety and that of others; therefore we kindly ask you to
read it carefully before installing and using the appliance.

For periodic maintenance checks and repairs, contact your nearest Technical Support Centre and only
use original spare parts. Failure to comply with this provision shall forfeit the warranty right.

All installation and commissioning operations must exclusively be performed by technically skilled
installers, in compliance with the instructions of the Manufacturer and in compliance with national
standards in force.

The “technical data” plate is located on the side panel of the appliance.
Note: The inappropriate or incorrect use of the appliance and failure to comply with installation rules shall
invalidate any liability by the Manufacturer.
2. INSTRUCTIONS FOR THE INSTALLER
The following instructions are intended for skilled installers, to perform installation, electrical and water
connection operations in the most correct manner and according to the safety regulations in force in the
country of installation of the appliance.
The Manufacturing Company shall not be liable for damage or harm to persons, pets or property arising
from installation errors. Nor are they responsible for any appliance breakage caused by faulty installation.
2.1 Storage
If the appliance is stored in a warehouse, the ambient temperature must never drop below 0°C. Before
switching on the appliance it must be brought to a temperature of
at least +10°C.
2.2 Transportation of the appliance
During transportation the appliance must be left in its packaging in order to protect it from any external
damage.
The weight of the appliance must also be taken into account in order to prevent overturning.
2.3 Unpacking the appliance
Remove the packaging before installation. It consists of a wooden pallet supporting the appliance and a
cardboard casing protecting it. Ensure the appliance has not undergone any damage during transport;
otherwise immediately alert your dealer and/or carrier.
2.4 Removal of the protective film
Before using the appliance accurately remove the special film protecting the stainless steel components,
avoiding glue residues on the surfaces; if required, immediately remove them using an appropriate non
flammable solvent. Do not use any tools that might scratch the surfaces or any acid-based or abrasive
detergents.
2.5 Protective film/package disposal
The Manufacture has been committed for years to increasing the environmental compatibility of its
equipment, with continuous efforts to reduce energy consumption and waste. The Manufacturer intends
to protect the environment and recommends to dispose of all different types of material, in the appropriate
separate collection containers.
The protective film and packaging must be disposed of in strict compliance with the regulations in force in
the country of installation of the appliance. The various materials (wood-paper-carton-nylon-metal tacks)
that may comprise the packaging are potentially dangerous and must be kept out of reach of children and
animals; they must be duly separated and delivered to the respective collection centres (recycling centres).
In any case please adhere to the local environmental protection regulations.
2.6 Placement
Check the place of installation making sure that the transit areas (any doors and corridors) are sufficiently
wide and the floor supports the appliance’s weight (the appliance’s weight and dimensions with/without
pallets are provided in the attached “Technical Data Sheet”). The appliance must be transported with
mechanical means (e.g. pallet jack). The installation rooms must be well-ventilated with permanent aeration