Maxim Edger
Tool Tips
Operation & Safety
ME4HWT
Safety Practices:
Application
: Edging and light trenching
DO NOT operate the unit without
reading and understanding
owner’s manual. Failure to learn
operation instructions and safety
procedures could result in
equipment or property damage,
personal injury or death.
DO NOT operate the unit under
the influence of alcohol, drugs or
while taking medication that
impairs the senses or reactions.
Before starting the engine
Step
1
Check Edger. Be sure all bolts are tight.
2
Check oil and fill according to the engine owner’s manual
Make sure all guards are in place and you know how to
stop the machine and disengage blade.
3
Starting the engine
Step
Move fuel valve lever to the
on position.
1
DO NOT allow unauthorized or
untrained people to operate the
unit. Improper use of the
equipment may cause serious
injury or death.
To start a cold engine, move
the choke lever to the
closed position. To restart a
warm engine, leave the
choke lever in the OPEN
position.
2
DO NOT wear loose clothing while
operating the unit. Always wear
safety glasses and appropriate
safety equipment.
Keep hands, feet and other body
parts away from moving or
rotating parts of the unit.
DO NOT operate the unit with
faulty brake mechanism or with
out safety guards, shields or
covers.
DO NOT operate indoors or in an
area with poor ventilation. This
engine emits toxic carbon
monoxide.
DO NOT fuel while the engine is
running.
DO NOT overfill the fuel tank.
After refueling, make sure the
tank cap is closed properly and
securely.
Move the throttle lever to
the mid point position on
either the engine or the
cross bar of the edger.
3
Turn the engine switch to
the on position
4
Pull the starter grip lightly until you feel resistance, then
pull briskly in the direction of the arrow as shown below.
Return the starter grip gently.
5
Step
Shut Down instructions
Move the throttle on the cross brace to the minimum or off
position.
1
2
Turn the engine switch to the OFF position
Operation instructions:
Action
Step
Decide which blade configuration is appropriate for your
application. For edging, only one blade is needed.
Remove one blade and a spacer for greater efficiency.
1
DO NOT smoke or allow open
flames or sparks during refueling.
For shallow trenching for invisible pet fencing or low
voltage wire, use two star blades with the spacer.
2
Edging depth is set with the blade control lever. When
edging an area for the first time it may be desirable to set
the depth lower to establish a trench for the blade for
future edging.
©
MTA Distributors of TN & KY, Inc. All rights reserved. 2008
ME4HWT
3
YARD RENTS
