Maxi Comet Executive Exec-56-G, Инструкция по эксплуатации, Страница: 49 / 244

Comet Executive Gas Operating Guidelines
3-7
10. Restart the unit.
11. Adjust the TEMPERATURE control dial
to waxing temperature, approximately
300° F (150° C).
12. After 15 seconds, listen for sounds indicat-
ing the pilot ignition sequence has started
and the pilot burner is igniting. The HEAT -
ING indicator lamp should be lit.
13. Wait approximately 5-10 minutes for the
ironing cylinder to reach proper waxing
temperature.
Waxing
Standard Ironing Cylinder
Daily waxing of the ironing cylinder ensures it
is coated correctly, allowing the flatwork to slide
easily across the cylinder surface.
This produces the best flatwork finish,
eliminates creases, prolongs return ribbon life,
prevents the flatwork from sticking to the ironing
cylinder, and protects the temperature contact
shoes from excessive wear.
Chrome Ironing Cylinder
Chrome-plated ironing cylinders may require
less frequent waxing. However, if excessive static
build-up is causing flatwork to stick to the return
ribbons or is affecting machinery down-stream of
the ironer, occasional waxing may be beneficial.
In addition, occasional waxing may help
prevent excessive wear on the temperature
contact shoes.
Required Tools
Chicago Dryer Company powdered
wax or pure Karagami equivalent
Waxing cloth
Perform only when the unit is
RUNNING and HOT.
Use Extreme Caution.
1. If the unit is not running, perform Start-
Up on page 3-6 .
2. Turn the SPEED CONTROL knob to a
low speed.
3. Set the ironer temperature to 300° F (150°
C).
NOTE:
Use only a standard
sheet or table cloth dedicated
solely to waxing the ironing
cylinder.
TOC INDEX