MAXDATA PLATINIUM 9000-2R, Руководство пользователя

Страница: 5 / 17

5
MAXDATA PLATINUM 9000-2R Server
Safety Precautions
The Following safety symbols are used in this manual:
WARNING
Failure to follow these guidelines may result in personal injury or even death
CAUTION
Failure to follow these guidelines may result in damage to the system or its
components

NOTE
General usage tips
WARNINGS
The power supply in this product contains no user-serviceable parts. There may be more than one
supply in this product. Refer servicing only to qualified personnel.
Do not attempt to modify or use the supplied AC power cord if it is not the exact type required. A
product might be equipped with more than one AC power cord.
The power button on the system does not turn off all system AC power. To remove all AC power
from the system, you must unplug each AC power cord from the wall outlet or power supply.
To avoid injury from electrical and mechanical hazards, chassis covers should only be removed by
qualified service personnel.
Safety Steps
Whenever you remove the chassis covers to access the inside of the system, follow these steps:
1. Turn off all peripheral devices connected to the system.
2. Turn off the system by pressing the power button.
3. Unplug all AC power cords from the system or from wall outlets.
4. Label and disconnect all telecommunication cables and all other cables connected to
I/O connectors or ports on the back of the system.
5. Provide some electrostatic discharge (ESD) protection by wearing an anti-static wrist
strap attached to chassis ground of the system – any unpainted metal surface – when
handling components.
6. Do not operate the system with the chassis covers removed.
After you have completed the six safety steps above, remove the covers as follows:
1. To open the top back cover, push the sliding latches on the top of the cover and pull the
cover toward the back of the chassis.
2. To remove the top back cover, continue to slide the cover toward the back of the chassis
until it reaches the end-stops. Press the latch on the left rail slide and pull the cover until it
clears the chassis.
3. To remove the top front cover, loosen the two captive screws on either side of the cover,
slide the cover toward the front of the chassis until it stops, then lift the cover off.
4. Always replace the covers before operating the system.