Maxcess MAGPOWR DTR-65, Инструкция по установке и эксплуатации

Страница: 41 / 45

7–1 TROUBLESHOOTING
www.maxcessintl.com MAGPOWR DTR-65 MI 850A349 1 D
Fault description Probable cause Solution Reference
Er 10 at power-up Sensor White (S+) or Black (S-
) wire disconnected Check sensor wiring. Figure 3. DTR-65 wiring
Er 11 at powr-up Sensor Red (P+) wire
disconnected Check sensor wiring. Figure 3. DTR-65 wiring
Er 12 at power-up Sensor Green (P-) wire
disconnected Check sensor wiring. Figure 3. DTR-65 wiring
Er 13 at power-up Sensor Failure or other mis-
wiring error Example: Green
and White wire swapped,
etc. Check sensor wiring. Figure 3. DTR-65 wiring
Display not lighted No power Check power wiring Figure 3. DTR-65 wiring
Fuse(s) blown Check fuse(s) in DTR-65. Fuse ratings in Specifications;
p. 8-1
Fuse Replacement; p. 6-1
Analog outputs not
changing with the
displayed tension Analog output shorted Check Analog output wiring. Figure 3. DTR-65 wiring
Analog output range
misconfigured Check parameters P.06
through P0.11. ––
Analog output not calibrated Perform output calibration
CAL0. ––
Alarm output not working Alarm not wired correctly Check alarm wiring. Figure 3. DTR-65 wiring
Alarm not configured
correctly Check parameters P.13
through P.18 ––
Remote zero not zeroing
tension Remote zero input not wired
correctly Check remote zero wiring. Figure 3. DTR-65 wiring
Digital input threshold level
not set correctly Check parameter P.12 ––
Displayed tension is
reading negative value
with increasing tension. Tension polarity is wrong Check parameter P.20. ––
Cannot change
parameters or perform
calibration. Password protection is active Enter the password into P.00 to
unlock the DTR-65.
The master unlock password is
6195. ––