5–3
PARAMETERS
www.maxcessintl.com
MAGPOWR DTR-65
MI 850A349 1 D
Digital input threshold
Parameter # Description
Default
Range
P.12
Sets the digital input threshold for either 5V or 24V
operation.
When set for 5V, the threshold between on and off
is 2.5 volts with 20% hysteresis.
When set for 24V, the threshold between on and
off is 12 volts with 20% hysteresis.
24 volts
n/a
Calibrate the analog outputs (not normally changed)
CAL0 – These parameters set the offset and gain for the outputs to calibrate the outputs to real
volts or real current. The parameters compensate for component tolerances on each DTR-65.
These parameters are calibrated at the factory and are not reset by the power-up function reset
parameters to default.
If these need to be changed connect a volt meter or current meter as appropriate to the output
that is being calibrated.
Parameter # Description
Range
C0.1
Sets the 0 to 10V output to 0%.
Change the value until the meter reads 0.00 volts
{0, 9999}
C0.2
Sets the 0 to 10V output to 100%.
Change the value until the meter reads 10.00 volts
{0, 9999}
C0.3
Sets the 4 to 20mA output to 0%.
Change the value until the meter reads 0.00 milliamps.
{-999, 9999}
C0.4
Sets the 4 to 20mA output to 100%
Change the value until the meter reads 20.00 milliamps
{0, 9999}
C0.5
Sets the 0 to 1mA output to 0%.
Change the value until the meter reads 0.00 volts or 0.00
milliamps
{0, 9999}
C0.6
Sets the 0 to 1mA output to 100%.
Change the value until the meter reads 10.00 volts or 1.00
milliamps.
{0, 9999}
