Helmet Liner
Part #: 2071-01 NIOSH Ref #: 03531021
Before use, refer to User’s Instructions, P/N 03521015, for detailed System instructions and information.
P/N 03531021 REV B
NOTE:
Four Helmet Mounting Snaps (arrows
at right) attach the Helmet Liner to the Helmet.
1. Position the Liner near the Helmet inside (A).
The Liner Cord Slot (red arrow) allows the
Liner to install with the Power Cord attached
to the Helmet. Place the Liner between the
Power Cord and the Helmet.
3. Secure one front Liner Snap to the Helmet Snap by pressing the Liner Snap firmly to the Helmet Snap. A click
occurs when the snap is secured. Repeat for the other front Liner Snap. Repeat for each rear Liner Snap (B2).
A
B1
2. Secure the Liner to the Helmet.
Begin by securing the Liner front edge under and
against the front lip of the Helmet (B1, red arrow). The
Liner front should be “caught” in this recessed area at
the Helmet front.
Top Left Top Right Bottom Left Bottom Right
B2
1 of 2