Matrox Solios eA, Установка и справочник по оборудованию, Страница: 61 / 196

Matrox Solios eCL/XCL acquisition section 61
Dual-Base/single-Medium and single-Full boards
Matrox Solios eCL/XCL dual-Base/single-Medium and Matrox Solios
eCL/XCL-F boards each have programmable LUTs.
In dual-Base mode, the LUTs can be operated in the following configurations per
acquisition path
1
:
• 8 palettes of one, two, three, or four 256-entry 8-bit LUTs.
• 4 palettes of one or two 1024-entry 8- or 16-bit LUTs.
• 1 palette of one or two 4096-entry 8- or 16-bit LUTs.
In single-Medium and single-Full modes, the LUTs can be operated in the
following configurations:
• 8 palettes of one, two, three, four, or eight 256-entry 8-bit LUTs.
• 4 palettes of one, two, three, or four 1024-entry 8- or 16-bit LUTs.
• 1 palette of one, two, three, or four 4096-entry 8- or 16-bit LUTs.
Instead of being mapped through a LUT, 14- and 16-bit data by-pass the LUTs.
Communication
For each acquisition path, two LVDS pairs are used to transmit and receive
asynchronous serial communication between the video source and the board.
These signals are handled by the Universal Asynchronous Receiver/Transmitters
(UARTs).
For each acquisition path, four camera control output signals are also available.
These are general-purpose signals that are sent to the video source.
1. For example, two 1024-entry 8-bit LUTs can map 2-tap 10-bit data to 8-bit values. In
addition one 1024-entry 8-bit LUT can map 1-tap 10-bit data to 8-bit values.