Matrox Mura D-Series, Руководство по сборке системы

Страница: 54 / 88

54 Matrox Display Wall – System Builder’s Guide
ASUS WS C621E SAGE
Configurations
D-Series based controllers Third-party based controllers
Validated Yes No foreseeable compatibility issues
Maximum number of cards
supported
7
Maximum supported
Mura IPX Series
6
Maximum supported
D-Series
4
Motherboard ASUS WS C621 SAGE
Chipset Intel C621
Processor Intel® Xeon® Bronze 3104 Dual CPU @ 1.70 GHz, or
Intel® Xeon® Silver 4210R Dual CPU @ 2.40 GHz
Heatsink (for CPU) LGA 3647
System BIOS version 6102, 2019-12-17
System memory 32 GB DDR4 ECC-RDIMM
Chassis Chenbro RM41300-FS81
Power supply 850 W (P/N:EVGA Supernova 850G3)
PCIe expansion slots

3 PCIe ×16 3.0 slots (×16 mechanical, ×16 electrical)

2 PCIe ×16 3.0 slots (×16 mechanical, ×16 / ×8 electrical)

2 PCIe ×16 3.0 slots (×16 mechanical, ×8 electrical)
Notes

The chassis must be ordered from Chenbro. Power supply isn’t included with the chassis.
 Only the front chassis fan that comes with the Chenbro chassis must be changed to 120 mm x 120 mm x
25 mm
113 CFM.
 The chassis fans must run at full speed. To change the fan speed, go to the system BIOS main page (EZ
mode)

select
QFan Control

select the header to which the fans are connected

change from
Standard
to
Full Speed
and apply the changes.

The dust protection filter in the front door must be removed for proper system ventilation.
 To use the on-board graphics, make sure the
3-pin VGA_SW1 jumper
is set to
Enable
on the motherboard. Then,
install the VGA bracket cable that comes with the motherboard in an empty slot and connect to the internal
VGA connector VGA_HDR1 on the motherboard.

In the system BIOS, go to

Platform Configuration

Miscellaneous Configuration

then set
Active Video
to
OFFboard
.

Make sure to have the following default settings for Above 4G Decoding. In the system BIOS, go to
Advanced

PCI Subsystem Configuration
, then set
Above 4G Decoding
to
Enabled
and set
First VGA 4G Decode
to
Auto
.

On-board console support with D-Series controller. Requires 3.05 or later drivers.
Slot
D-Series based controller Third-party based controller
Main Option Main Option
PCIEX16_1 D1480 B Third-party graphics hardware
PCIEX16_2 MURAIPXI-E4JHF A MURAIPXI-E4JHF A
PCIEX16_3 D1480 A, B Third-party graphics hardware A
PCIEX16_4 MURAIPXI-E4JHF A MURAIPXI-E4JHF A
PCIEX16_5 D1480 A,B Third-party graphics hardware A
PCIEX16_6 MURAIPXI-E4JHF A MURAIPXI-E4JHF A
PCIEX16_7 D1480 A, B Third-party graphics hardware A