Matrox M264, Инструкция по установке и эксплуатации

Страница: 16 / 74

4
Chapter 2, Preparing for the DSX Installation
Before you install your DSX cards
Read the following information carefully before attempting to install DSX cards in
your computer system.
Start with a functioning system
Before attempting any DSX installation, you should have a computer with a
DSX-supported operating system fully installed and functioning smoothly. This will
avoid potential problems later on.
Configuring your system’s power management
Before installing DSX hardware, you must configure your system’s power
management to optimize the performance of your DSX system. Your system’s power
management is configured in your computer’s BIOS and, on a Windows operating
system, in your Windows power options.
BIOS power management configuration
Some computers provide advanced power management settings in the BIOS. If these
settings are available in your computer’s BIOS, you must configure them as follows:
• For Intel Dynamic power Technology , set Enhanced Intel SpeedStep
Technology to Disable .
• For System Power Options , set PCIe ASPM Support to Disable .
For details on how to configure your computer’s BIOS settings, see your computer’s
documentation.
Windows power management configuration
The procedure for configuring your Windows power management settings depends on
your version of Windows as explained below.
° On Windows 10, 8, 7, Server 2012, or Server 2008:
1
In Control Panel ,
$
On Windows 10, 8, or 7, choose Hardware and Sound or System and
Security > Power Options .
$
On Windows Server 2012 or 2008, choose Hardware > Power Options .
¦ Note
On Windows 10, 8, or 7, Hardware and Sound and System and
Security appear if you are in the default Category view. Otherwise, only Power
Options appears.
2 Select High performance as the power plan, and click Change plan settings .
3
Click Change advanced power settings , and customize the settings (if
available) as follows:
$
For Hard disk , set Turn off hard disk after to Never .
$
For USB settings , set USB selective suspend setting to Disabled .