Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 88 / 160

76
Chapter 7, Configuring Your DigiSuite LX MAX
The DigiSuite Configuration window opens, similar to this one:
In most cases, all your DigiSuite cards are grouped into a single card set.
Under the
Card Set 1
tab, tabs are provided for each card you can
configure in the set. To configure a card, click its tab.
The
General
tab displays basic information for a card set, and lets you
select your genlock source and editing aspect ratio. The
VTR Settings
tab
will be present for Card Set 1 only if the VTR driver is installed. Use this
tab to configure your VTR for RS-422 device control with DigiTools and
various nonlinear editing programs.
Default button
To restore the factory default settings for your card set, click the
Default
button. You can choose which settings you want to restore, such as your
DigiSuite LX or VTR settings.
Save and Load buttons
The
Save
button lets you save your configuration settings to a .cfg file. To
apply those settings, click the
Load
button and select your .cfg file. Then
select which settings you want from the file, such as
DigiSuite LX
, and
click
Open
.
¯Note Once you’ve configured all your cards, it’s a good idea to save the
settings for your card set to a .cfg file for backup purposes.