Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 114 / 160

102
Chapter 7, Configuring Your DigiSuite LX MAX
Manually adjusting your recorder’s calibration
settings
°Important
In most cases, the Calibration Wizard will correctly adjust
your VTR’s calibration settings for frame-accurate recording. You should
change these settings
only if you’ve run the Frame Accuracy Test Wizard
to determine the amount of adjustment you need to make.
¬
To manually adjust your recorder’s calibration settings:
1 Click the Card Set 1 tab, then the VTR Settings tab.
2 Make sure Enable Recording is selected, then click Set Up Recorder .
3 Click Advanced Settings . This displays the Calibration Settings
dialog box:
4
Adjust the
Edit On Delay
and
Edit Off Delay
values as needed (see
step 5 on page 101 ). If you want to return the calibration settings to
their default values, click
Default
.
5
Click
OK
to save your changes.
6
Run the Frame Accuracy Test Wizard again to ensure that the new
calibration settings are correct.
¯Note The
Use Device Cue
option should be selected only if the RS-422
device control has problems cueing your VTR, such as when you cue to a
clip’s In or Out point using DigiTools or Adobe Premiere. If the
Calibration Wizard or Frame Accuracy Test Wizard detects that there is a
problem cueing your VTR, you’ll be prompted to restart the wizard and the
Use Device Cue
option will automatically be selected for you.