Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 113 / 160

101
Configuring your VTR settings
Checking the frame accuracy of your recorder
using the Frame Accuracy Test Wizard
The Frame Accuracy Test Wizard guides you through a sequence of steps
to check the frame accuracy of your recorder. It records color bars, time
code, and a series of Matrox logos onto your tape. You’re then prompted to
check that the first and last frames in the series of logos appear at provided
Cue In and Cue Out time codes.
¯Note
You can use the same tape to run the Frame Accuracy Test Wizard
that you used to run the Calibration Wizard.
¬
To run the Frame Accuracy Test Wizard:
1 Set your VTR to record time code, and load a recordable tape that has
been striped with continuous and consecutive time code.
2 Click the Card Set 1 tab, then the VTR Settings tab.
3 Make sure Enable Recording is selected, then click Set Up Recorder .
4 Click Validate Calibration , then follow the instructions that appear on
the screen.
5 If you find that your recorder is not frame accurate, you’ll need to
manually adjust its calibration settings as follows:
✄
Note the number of frames you had to rewind or advance from the
provided
Cue In time code in order to locate the first frame of the
Matrox logo. Adjust the current Edit On Delay value by this amount
(either deduct the number of frames you rewound, or add the number
of frames you advanced).
✄
Note the number of frames you had to rewind or advance from the
provided
Cue Out time code in order to locate the last frame of the
Matrox logo. Adjust the current Edit Off Delay value by this amount
(either deduct the number of frames you rewound, or add the number
of frames you advanced).
For details on how to manually adjust your recorder’s calibration
settings, see the next section.