Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 112 / 160

100
Chapter 7, Configuring Your DigiSuite LX MAX
✄
Manually adjust your recorder’s calibration settings, if needed.
✄
Stripe your tapes.
For instructions on how to perform these operations, see the following
sections.
¯Note For details on how to set up RS-422 device control on DigiSuite in
Adobe Premiere, see the “Defining Your Adobe Premiere Settings” chapter
of your
DigiSuite MAX User Guide .
Calibrating your recorder using the Calibration
Wizard
The Calibration Wizard guides you through a sequence of steps to calibrate
your VTR for frame-accurate recording. It records color bars, time code,
and a series of Matrox logos onto your tape, prompts you to locate the first
and last frames in the series of logos, then adjusts your VTR’s calibration
settings (
Edit On Delay
and
Edit Off Delay
) according to your response.
Although you can manually adjust your VTR’s calibration settings,
running the Calibration Wizard is the easiest way to obtain a frame-
accurate recorder.
¬
To run the Calibration Wizard:
1 Set your VTR to record time code, and load a recordable tape into
your VTR.
2 Click the
Card Set 1
tab, then the
VTR Settings
tab.
3 Make sure
Enable Recording
is selected, then click
Set Up Recorder
.
4 Click
Calibration Wizard
, then follow the instructions that appear on
the screen.
5 When you’ve finished running the Calibration Wizard, you should test
the frame accuracy of your recorder as explained in the next section.