Matrix SIMADO GFXD1111S, Системное руководство

Страница: 117 / 194

Matrix SIMADO GFXD1111S V3 System Manual 111
Port Parameters-FXO
SE should program various FXO Port parameters for the functioning of SIMADO GFXD1111S. All these parameters
are described below:
Enable/Disable FXO Port:
SE can enable/disable the FXO Port as per the requirement of the User. Disabling of FXO Port is required only in
cases like problem in the exchange, hardware failure, etc. GFXD1111S will not route calls to/from FXO Port, when
the FXO Port is disabled.
Use following command to enable/disable the FXO Port:
211-Code-#*
Where,
By default, the FXO port is enabled.
Dial Type:
SIMADO GFXD1111S supports two methods to out-dial the number on the FXO Port.
• Pulse
• DTMF
Select appropriate dial type depending on the requirement of the FXO Port.
Use following command to program the Dial Type for the FXO Port:
212-Code-#*
Where,
By default, Dial Type selected for FXO port is 'Tone (DTMF)'.
Calling Line Identification and Presentation on FXO:
SIMADO GFXD1111S has the ability to detect the calling party number when the call originates on its FXO Port.
Different types of signaling are used by different exchanges of different countries for sending the calling party
number to the FXO Port. SIMADO GFXD1111S supports different types of CLI signaling for detection of Calling
Party's number on FXO Port. These are:
• None
• DTMF
• V.23 FSK
• Bellcore FSK
Use following command to program the CLI Type for the FXO Port:
214-CLI Type-#*
Code Meaning
0 Disable
1 Enable
Code Meaning
1 Tone (DTMF)
2 Pulse