287
Matrix SETU VFXTH System Manual
System Commands
Certain parameters of SETU VFXTH can be configured by dialing System Commands from a telephone connected
to the FXS Port. You can configure certain Network Parameters, like IP Address, Subnet Mask, Connection Type,
set the system to default and also view current IP Address, Subnet Mask, Connection Type, DNS and Gateway
Address by dialing System Commands.
To be able to view these details, the telephone connected to the FXS Port must have an LCD display.
To dial System Commands,
•
Pick up the handset of the telephone connected to the FXS Port of SETU VFXTH.
•
Dial
#19-Command Password
to enter programming mode.
You will get programming tone.
•
To change IP Address, dial
11-IP Address-#*
For example, to change IP address to 192.168.1.120, dial
11-192168001120-#*
Default: 192.168.1.100.
•
To change Subnet Mask, dial
12-Subnet Mask-#*
Where,
Valid range for Subnet Mask is 0, 128, 192, 224, 240, 248, 252, 254 and 255.
For example, to change Subnet Mask to 255.255.254.0, dial
12-255255254000-#*
Default: 255.255.255.000
•
To configure WAN Port Gateway IP Address, dial
13-Gateway Address-#*
Where,
Gateway IP Address is of 12 digits.
For example, to change Gateway Address to 192.168.9.10, dial
13-192168009010-#*
Default: Blank
To change IP Address to Blank, dial
13-#*
•
To select the Connection type, dial
10-Code-#*
Where,
Code is 1 for Static, 2 for DHCP, 3 for PPPoE
Default: Static
•
To enable/disable VLAN Tag, dial
31-Code-#*
Where,
Code is 1 for Enable, 0 for Disable
Default: Disable
•
To restore factory defaults, dial
51-Reverse SE Password-#*
Replace the handset. The system will restart.
•
To view Connection Type, dial
20-#*
and go On-hook
•
To view the Network IP Address, dial
21-#*
and go On-hook
•
To view the Subnet Mask, dial
22-#*
and go On-hook
