Matrix SETU VFX44L, Системное руководство

Страница: 60 / 195

Matrix
60 SETU VFX88L
/
VFX44L V1
System Manual
Call Hold
What’s this?
• Using this feature you can keep a call on hold and retrieve that call
when required.
• The held call is disconnected, if it is not retrieved before specified
time.
• For this, the gateway supports two types of Timers: Call Hold Alert
Timer and Call Hold Reject Timer.
• You can get indication of ‘held’ call if you go ON-Hook, by getting
‘Ring’ for period of Ring Timer (programmable) to indicate that there
is held party present.
How to use it?
User will follow the steps as mentioned below:
• Enable the feature from
‘Class of Service’
.
• Program the Alert timer and Reject timers.
• During speech if you want to hold a remote user, dial the
access code
Flash-1
in active call condition. If you go ON-
Hook, you will get ‘Ring’ indication after expiry of Alert timer.
• Dial
*81
to retrieve the Held Remote user.
How it works?
• The feature works only if enabled from Class of Service for the
specific FXS port.
• Call can be held, by dialing the access code only during
‘connected’ state speech condition.
• Access code for Call Hold is
Flash-1
and it is not programmable.
• If you dial access code and feature is allowed, you will get
confirmation tone till confirmation tone timer and you are in dial
state.
• In this state, you cannot make another call, but you can do
following:
• Can dial retrieve Hold Call Access Code.
• Can dial Emergency Number.
• If you dial access code or number other than above, you will get
‘Error Tone’.
• If you dial Emergency Number, after holding the call, the call will be
released.