Matrix SETU VFX44L, Системное руководство

Страница: 126 / 195

Matrix
126 SETU VFX88L
/
VFX44L V1
System Manual
Programming using Conventional Phone
What’s this?
• Following parameters for the Gateway can be programmed using
Phone:
• Static IP address for the Network port
• Subnet Mask
• For this user it is required to enter the Programming Mode using
phone.
How to enter Programming Mode using Phone?
• Get the IP address for the WAN port from the administrator.
• Go OFF-Hook.
• Enter the Programming Mode by: Dial Access Code
‘#19’
followed
by Password 1234 (default).
• During programming mode, if you go ON-Hook, you will get
Continuous ring. This is used to indicate that you are in
Programming mode. If you go off hook, you will get programming
tone (feature tone).
• If any feature is successfully set/cancel, you will get confirmation
tone for 5 seconds followed by programming tone.
• You will also get Error tone if invalid command or invalid value is
entered by the SE. The ‘error tone’ will be for 5 seconds followed by
programming tone.
• You can dial programming command during confirmation tone or
error tone.
• Enter
‘00#*’
to get out of programming mode.
How to Program IP Address of Network port?
Use following command to program the Network port IP address:
11-XXX XXX XXX XXX-#*
Where,
XXX XXX XXX XXX is the Network IP address. Network IP Address is
of 12 digits maximum
Each octet is of three digits. If only single digit is used then convert to
three digits and then enter. For e.g. To enter IP address 192.168.9.10,
enter command
11-192168009010-#*.
Valid range for each octet is 000-255.