e. Turn off power and disconnect the cord
f. Remove
four (4)
screws from console back and
remove cover
<Figure 26>
g. Remove the
four (4)
screws holding the iron plate to
the console frame
<Figure 30>
h. Remove the CF card from the console frame
i. Install replacement CF card
j. Screw on iron plate and console cover
k. Turn on power
l. Wait for the 7xi Setup Wizard to display
<Figure 31>
m. Using the left and right arrow to scroll pages, select
the appropriate settings for the following categories:
i.
Model
ii.
Language
iii.
Date, time, and time zone
iv.
Asset Management
v.
Serial number
n. Reboot the console by pressing
Enter 7 3 2 6 6 8
Enter
and wait until the welcome screen displays.
Note:
If the display shows 04A0, turn off the machine
and wait 30 seconds then turn on the machine
o. Press
Enter 3 0 0 1 Enter
to enter Service Mode
p. Verify the settings under the following tabs:
a. General
b. Network
c. Netpulse
d. Weather
e. TV
q. Press
HOME
button on screen
r. Press
Enter 3 0 0 5 Enter
and install all available
software updates
s. Test unit
Replace Inverter and Inverter Wire
1. Remove
four (4)
screws from console back and
remove cover
2. Remove
four (4)
screws holding the iron plate to the
console frame
3. Unplug inverter wire
<Figure 32>
4. Remove
two (2)
screws holding inverter to lower
board
<Figure 33>
5. Install new wire and inverter
6. Reassemble console and test
Rewrite Compact Flash Card
1.
Connect CF card reader to your computer
2.
Copy good CF card
<Figure 30>
<Figure 31>
<Figure 34>
<Figure 32>
<Figure 33>
9|
Revision Date: [Enter Date] | Revised by: [Enter name or initials]
