MSC-UTX62L Product Manual
mtx.sync=0
>Get net.ip
net.ip=192.168.2.60
>
3.11.9 GetS Command
Protocol version 3.0
Gets system parameter values in Stored memory. The
can be used to query current Active values
of parameters and can also be referenced for more details.
Command
Description
GetS
Display all system parameter Stored values. Output consists of one parameter per line with
the parameter identifier separated by an equals ‘=’ character and the value.
GetS Parameter
Display the Stored value of a single parameter or a subset of parameters under a given
parameter node.
3.11.10 Help Command
Display command reference information.
3.11.11 IP Command
NOTE:
Superseded by the
net.ip
Query or assign the system IP address. This setting is saved and recalled on power up.
WARNING:
Maintaining the ability to access a device's web page and for Remote Panel devices to be able to
communicate with Routers requires that the IP address is known, valid and systems are configured to be on the
same IP network. In the event that the IP address of a system is unknown refer to the
section for this device.
Command
Description
Ip
Query IP address of the system.
Ip IP
Set IP address of the system.
Example querying and assigning the IP address
>IP
192.168.2.60
>IP 192.168.2.61
>
3.11.12 LockStatus Command
Routers only
Query the video lock status and video rate of a Video Router's outputs. This command is only supported on
Page 30 of 60
© 2013-2020 Matrix Switch Corporation