MSC-5-3232 Product Manual
Query or assign the system IP address. This setting is saved and recalled on power up.
WARNING:
Maintaining the ability to access a device's web page and for Remote Panel devices to be able to
communicate with Routers requires that the IP address is known, valid and systems are configured to be on the
same IP network. In the event that the IP address of a system is unknown refer to the
section for this device.
Command
Description
Ip
Query IP address of the system.
Ip IP
Set IP address of the system.
Example querying and assigning the IP address
>IP
192.168.2.60
>IP 192.168.2.61
>
3.11.13 LockStatus Command
Routers only
Query the video lock status and video rate of a Video Router's outputs. This command is only supported on
some Router systems. Unsupported systems will return an “Unsupported command” error on version 2.1 and
newer protocol versions and blank output on older versions.
Command
Description
LockStatus
Displays Video lock status and rate detection for outputs. Format is one decimal number
per output (0: Unlocked, 1: SD, 2: HD).
Example for a 16x4 system (SD, HD, Unlocked, Unlocked)
>LockStatus
1,2,0,0
>
3.11.14 MAC Command
NOTE:
Superseded by the
net.mac
Query system Ethernet MAC address.
Command
Description
MAC
System Ethernet MAC address in hh:hh:hh:hh:hh:hh where each hh is a pair of hex digits.
Example
>MAC
00:50:C2:8B:DF:FE
>
Page 31 of 61
© 2013-2016 Matrix Switch Corporation