Dec. 2018 Rev 1.0
http://www.mateksys.com/?portfolio=fchub-12s
No output on
SW12V
pad by default if PINIO is not enabled
Any unused RX/TX/motor/PWM pad can be used for PINIO
e.g. connect PINIO pad to R5 of F405-STD/F722-STD
CLI
resource
to locate RX5 pin name
RX5 pad is
D02
then
resource SERIAL_RX 5 none
resource PINIO 1 D02
set pinio_box = 40
save
Go to modes tab and assign an AUX channel to the USER1 mode. Click
SAVE
.
Flip the switch and test
*** Following pads are used for MATEKSYS FC via FFC
VTX: Video transmitter signal
T5: UART5_TX on F405-STD/F722-STD
R5: UART5_RX on F405-STD/F722-STD
+ & - : LiPO & ESC power pads
8~60V (3~12S)
PDB: 4x70A cont. 4x110A burst.
5V: BEC 5V, 5A cont. 6A burst
12V: BEC 12V, 4A cont. 5A burst
3V3: LDO3.3V 500mA cont.
G: Ground
S1/S2/S3/S4: ESC signal
TLM: for BLheli32 ESC telemetry,
5x TLM pads are all shorted together
Curr: current sensor signal, 440A range, scale
75
3~8S Battery
Bridge middle & left pads
= Battery voltage
It can be connected to FC for voltage detection and power supplier
Use FC default voltage scale, e.g.110 on MATEKSYS FC STD series
LAYOUT
VBAT Applications
SW12V & PINIO
9~12S Battery,
Flight controller MUST has no board 5V regulator ! ! !
Bridge middle & right pads
Use for FC voltage detection only
Voltage meter scale 210 on MATEKSYS FC STD series
7~12S Battery,
Flight controller has on board 5V regulator
If the onboard regulator doesn’t support 7~12S input
Power your FC via 12V pad
FC can’t detect battery voltage
FFC
75
110
210
SW12V OFF SW12V ON
MATEKSYS PDB FCHUB-12S
QUICK START GUIDE
