The Mate Logo and ULTRA TEC are registered trademarks of Mate Precision Tooling Inc.
Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone 763.421.0230 • 800.328.4492 • Fax 763.421.0285 • 800.541.0285
mate.com
Installation/Length Adjustment Ultra TEC
®
1 1/4” B Station Fully Guided Assembly
ATTACH
1
TO
2
…
Engage threads by rotating
punch approximately 8 turns
INSERT TIP OF CLIP TOOL INTO NOTCH
ON CLIP IN PUNCH GUIDE
3
, (VISIBLE
IN PUNCH GUIDE CUTAWAY)…
Push latch pin down with
tool. Latch pin will release
stripper clip, which will pop
out ready for installation of
the stripper.
NOTE: Stripper clip is assembled
with the guide and is not removable.
NOTE: Head of latch pin is visible in
the notch cut into the stripper clip
(punch end view)
SELECT
ANGLE
SETTING...
INSERT
1
AND
2
INTO
3
.
SNAP
1
AND
3
TOGETHER...
INSERT
4
INTO
3
OVER TIP OF
2
…
Items
3
and
4
are
precision fit components—
do not try to force fit or
damage may result. Keep
parts free of dirt or metal
shavings. If there is a lug on
4
, align lug with
corresponding slot in
3
.
LOCK
4
INTO
3
WITH INTEGRAL
STRIPPER CLIP…
NOTE: Stripper clip is
assembled with the guide
and is not removable. Use
finger pressure to push
stripper clip in until latch
pin snaps in place and
holds stripper securely.
The stripper clip will be
flush with or below punch
guide surface.
PUSHING DOWN LOCK BUTTON WILL
ALLOW THE CANISTER TO ROTATE...
ADJUST PUNCH
LENGTH…
While pushing down
lock button, set punch
face flush with stripper.
Turn canister six clicks
clockwise to retract
punch .048(1.2), to
provide proper stripper
lead.
