BCILMD
Parts Breakdown:
Operating Instructions:
1. Place bearing cup against the magnetic side of installer.
2. Insert the second bearing cup into driveline.
3. Align the installer over both bearing cups.
4. Turn the forcing screw by hand or with an impact wrench.
5. Ensure that the U-joint cross and bearing cup are aligned.
6. Both of the bearing cups will be pressed in at the same time.
7. Repeat steps 1-6 on remaining bearing cups.
Note:
Tool may have flipped around to reach correct bearing cup depth to install retaining clip.
Part Number
Description
Qty.
20201
20202
20201
20203
20204
C-Frame
1
20202
Forcing Screw
1
20203
Flat Press Adapter
1
20204
O-Ring
1
2101004-17
Safety Warning:
Read all instructions and warnings before attempting to use this product.
Failure to comply can result in damage, injury, or possibly death.
Consult the vehicle’s service manual before using this product for specific removal instructions.
• Stay alert! Be aware of your surroundings and use
common sense when operating this tool.
• Inspect tool for damage prior to using; do not use if
tool is in unsafe condition.
• Always use safety equipment. Approved face and eye
protection must be worn in the work area at all times.
• Keep hair, clothing, jewelry, and gloves away from any
moving parts at all times.
