Masterflex ISMATEC 78018-50, Руководство по эксплуатации, Страница: 49 / 65

3-40 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 3: Operation
Masterflex
Using Program Modes
Custom programs will appear in alphabetical order at the bottom of the Mode Selection Screen. If there are
multiple programs tapping SCROLL will display additional pages.
General Preparation:
• Confirm the correct transfer tubing is securely attached to the pump head.
• Confirm all fluids and containers are ready.
• Switch the drive on using the power switch located at the rear of the drive.
NOTE: If Manage User
is enabled you may be prompted for a Username and Password (for further information see " User
Management " on page 3-9). The touchscreen display will revert to the previously used operation mode.
• Confirm that the pump head has been calibrated by checking that Calibration Complete is displayed
on the Program Information Screen (for further information see " Pump Head Calibration " on page
3-12).
• If required, prime the pump (for further information see " Priming the Pump " on page 3-11).
To use a program:
1. Select the desired program from the Mode Selection Screen. The Program Run Screen will be displayed.
2. Tap START to begin the pump drive operation using the displayed program settings.
3. If required, Tap PAUSE or STOP during operation.
NOTE:
The pump cannot be paused during
Continuous Mode operation.
NOTE:
• Tap INFORMATION to view the selected program's settings.
• Individual settings cannot be edited from the Program Run Screen.
Editing a Program
NOTE: If Manage User is enabled only users with authorization can create and modify programs (for further
information see " User Management " on page 3-9).
To edit a program:
1. Tap EDIT located next to the desired program name on the Mode Selection Screen (
NOTE:
If there
are multiple programs, tap SCROLL to display additional pages). The Program Edit Screen will be
displayed.
2. Edit the settings for the selected mode as desired. For instructions on editing individual mode settings see:
• " Adding a New Program: Continuous Mode " on page 3-36.
• " Adding a New Program: Time Mode " on page 3-36.
• " Adding a New Program: Volume Mode " on page 3-37.
• " Adding a New Program: Analog Input Mode " on page 3-39.
•
NOTE:
Once the individual mode settings have been edited and saved the Program Edit Screen will
be displayed.
3. Tap CONFIRM to save or CANCEL to discard changes and return to the Mode Selection Screen.