17
18
2-GALLON (7.6 L) AIR COMPRESSOR - 058-7000-2
2-GALLON (7.6 L) AIR COMPRESSOR - 058-7000-2
ITEM
DESCRIPTION / REASON
SERVICE
INTERVAL
Drain the
tank
Through normal operation of your air compressor, condensation water will
accumulate in the tank. To prevent corrosion of the tank from the inside,
condensation must be drained at the end of every workday. Be sure to
wear protective goggles. Relieve the air pressure in the system and open
the drain valve on the bottom of the tank to drain. In cold conditions, it is
especially important to drain the tank after each use to reduce the chance
of problems resulting from the freezing of condensation water.
NOTE:
Refer to
To drain tank
, page 18.
Daily
Check
the valve
Pull/activate the safety valve daily to ensure that it is operating properly
and to clear the valve of any possible obstructions.
Daily
Test for
leaks
Check that all connections are tight. Small leaks in the tank, hoses,
connections or transfer tubes will substantially reduce the air compressor
and tool performance. Spray a small amount of soapy water around
the area of suspected leaks with a spray bottle. If bubbles appear,
repair, replace or re-seal the faulty component. Do not over tighten any
connections.
Monthly
Storage
Before storing the air compressor, do the following:
•
Drain tank (see
Oper ating Instructions
paragraph in the
Maintenance
section of this manual for the correct procedure).
•
Use an air blow gun to clean all dust and debris from the compressor.
•
Disconnect and wind up the power cord.
•
Clean the ventilation openings on the motor's enclosure.
•
Drain all moisture from the tank.
•
Pull the pressure safety valve to release all pressure from the tank.
•
Cover the entire unit to protect it from moisture and dust.
•
Store the air compressor in a clean and dry location.
•
In cold weather, store the compressor in a warm building when it is
not in use. This will reduce problems related to starting the motor and
the freezing of water condensation.
Prior to
storing
To check safety valve
WARNING!
Risk of bursting. If the safety valve does not work properly, over-
pressurization may occur, causing air tank rupture or an explosion.
•
Before starting compressor, pull the ring on the safety valve (F)
to make sure that the safety valve operates freely. If the valve
is stuck or does not operate smoothly, contact a trained service
technician.
To drain tank
NOTE:
Allow unit to cool before draining tank. Drain valve becomes hot during operation.
1.
Set the power switch (C) to the
0
(off) position.
2.
Turn air pressure regulator knob (G) counter-clockwise to set the outlet pressure to zero.
3.
Pull and hold ring on safety valve (F), allowing air to bleed from the tank until air pressure is
minimized.
4.
Place suitable container under unit to catch water.
5.
Slightly tilt unit and turn drain valve (J) counter-clockwise to open.
WARNING!
Risk of bursting. Water will condense in the air tank. If not drained,
water will corrode and weaken the air tank, causing a risk of air tank rupture.
6.
After the water has been drained, close the drain valve (J) (clockwise). The air compressor can
now be stored.
WARNING!
If any of the following symptoms appears while operating the product, stop
using the product immediately, or serious personal injury could result. Only an authorized
service centre should perform repairs on this product.
Disconnect the electrical plug and disconnect any tools from air supply before attempting any
adjustment.
NOTE:
Troubleshooting problems may have similar causes and solutions.
M
AI
NT
EN
AN
CE
M
AI
NT
EN
AN
CE
058-7000-2-Air-Compressor-2G-EN-03.indd 17-18
6/11/12 8:14 AM
