Insta
Swap
REPLACING THE POWER LEAD, SHOULDER PADS AND WAIST BELT
7
Removing the power lead:
1
.
Disconnect the connector plug
from the machine.
2
.
Slide lead out between
back support and machine.
Remove from cable restraint.
Installing the
power lead:
1
.
Feed approximately
45cm of lead between
back support and lower
body, then connect
plug into the socket.
Removing the shoulder straps:
1
.
Remove shoulder adjustment
strap from the buckle and loop
on the shoulder pad.
Installing the shoulder straps:
1
.
Start with the shoulder pad
loop entering the handle area.
Feed pad over the handle and
through the loop.
Removing the waist belt:
1
.
Manoeuvre the tri-slide to a
verticle position so it can slide out
through the slot.
Installing the waist belt:
1
.
Manoeuvre the tri-slide to a
vertical position so it can slide
into the slot.
2
.
Feed power lead
into cable restraint
leaving approximately
20cm of slack in the
cable at the plug end.
2
.
Remove shoulder pad from
the handle by feeding the pad
back through the loop end
around the handle.
2
.
Feed the shoulder
adjustment strap through
the loop and buckle on
the shoulder pad.
2
.
Push tri-slide out through
the slot.
3
.
Repeat on other side.
2
.
Push tri-slide in through
the slot.
3
.
Repeat on other side.
