For 4CH mode, Group A (CH1 and CH2) and Group B (CH3, CH4) both require stereo
input signal. All 4 channels will work independently.
For 2CH mode, Only Group A (CH1 and CH2) requires stereo input signal, Group B
(CH3, CH4) will receive the same signal as Group A. 2CH model is for source unit
that has only 1 stereo output signal.
The amplifier has dual input sensitivity differential inputs which will
receive either
High level (Speaker output) or Low level (RCA) signals from your car stereo's source
unit
.
When switch to PRE IN, The signal can be delivered to the amplifier using the low-
level
RCA outputs on the source unit
.
When switch to SPK IN, The high-level signal can be run from the source unit's
speaker outputs to the stereo RCA input on the end panel of the amplifier using the
HL01.
6.Input select (D1600.4 only)
7.Input
Level (D1600.4 only)
For auto turn on/off mode, D1600.4 amplifier offer 3 options: DC
REM:
When auto turn on to REM, please connect the unit REM terminal to the source
unit remote terminal with an 18AWG cable. This is the preferred mode.
DC OFFSET:
If the OEM source unit has no REM signal output, you can choose DC
OFFSET (Meanwhile, Input select switch to SPK IN mode) , DC OFFSET can turn
on/off EA series amp by detecting the 6V DC Offset from the OEM source unit
terminal.
AUDIO:
Audio mode can turn ON/OFF D1600.4 amp by detecting the audio signal
from source unit.
Note
: If the volume is too Low, The amp may fail to turn on. So
please check if the source unit volume is properly set.
Offset/Rem/Audio.
speaker
8. Auto Turn On (D1600.4 only)
9
10
11
10
12
12
13
14
14
13
9
9
10. X-over mode and frequency Control
9. Gain
When the X1/X10 button is set to the “out ” position the HPF range adjustments are
10Hz ~ 200Hz . When this button in set at the “ in ” the HPF range is from 100Hz ~2KHz.
(
D1600
.
4
without
function
of
multiple
10
times
X
-
over )
(Please refer to Table 1 to select cable and fuse)
